You mean that the ball position is merely the point where the Circle and the Plane line meet and that this must be passed through and not just swung at in order to achieve the desired result?
Wow! This stuff is good.
Probably so BUT . . . I think the CONSTANT is Low Point. Ball position can certainly change but LOW POINT is . . . well . . . Low Point. And for the procedure to comply with the Circle you must go down and out to Low Point . . . otherwise you traced a SPHERE. So you must go all the way down all the way out and and forward . . . if not the plane is compromised . . . probably by Steering. Steering thus achieving the dubious distinction of the 1st Snare.
And compliance with the Geometry of the Circle being inherently 2 dimensional the 1st Imperative is derived and met. Plane is the New Boss . . . same as the Old Boss Circle.
__________________
Aloha Mr. Hand
Behold my hands; reach hither thy hand
Last edited by 12 piece bucket : 06-15-2007 at 09:53 PM.
Probably so BUT . . . I think the CONSTANT is Low Point. Ball position can certainly change but LOW POINT is . . . well . . . Low Point. And for the procedure to comply with the Circle you must go down and out to Low Point . . . otherwise you traced a SPHERE. So you must go all the way down all the way out and and forward . . . if not the plane is compromised . . . probably by Steering. Steering thus achieving the dubious distinction of the 1st Snare.
And compliance with the Geometry of the Circle being inherently 2 dimensional the 1st Imperative is derived and met. Plane is the New Boss . . . same as the Old Boss Circle.
Exactly! And, very succinctly put.
An appreciation of this subject eludes the vast majority, I fear, and they will not improve until they "get it".
Steering Committee disband - and that is an order.
Hybrid Mode
